OLD | NEW |
(Empty) | |
| 1 /* orinoco_tmd.c |
| 2 * |
| 3 * Driver for Prism II devices which would usually be driven by orinoco_cs, |
| 4 * but are connected to the PCI bus by a TMD7160. |
| 5 * |
| 6 * Copyright (C) 2003 Joerg Dorchain <joerg AT dorchain.net> |
| 7 * based heavily upon orinoco_plx.c Copyright (C) 2001 Daniel Barlow |
| 8 * |
| 9 * The contents of this file are subject to the Mozilla Public License |
| 10 * Version 1.1 (the "License"); you may not use this file except in |
| 11 * compliance with the License. You may obtain a copy of the License |
| 12 * at http://www.mozilla.org/MPL/ |
| 13 * |
| 14 * Software distributed under the License is distributed on an "AS IS" |
| 15 * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See |
| 16 * the License for the specific language governing rights and |
| 17 * limitations under the License. |
| 18 * |
| 19 * Alternatively, the contents of this file may be used under the |
| 20 * terms of the GNU General Public License version 2 (the "GPL"), in |
| 21 * which case the provisions of the GPL are applicable instead of the |
| 22 * above. If you wish to allow the use of your version of this file |
| 23 * only under the terms of the GPL and not to allow others to use your |
| 24 * version of this file under the MPL, indicate your decision by |
| 25 * deleting the provisions above and replace them with the notice and |
| 26 * other provisions required by the GPL. If you do not delete the |
| 27 * provisions above, a recipient may use your version of this file |
| 28 * under either the MPL or the GPL. |
| 29 * |
| 30 * The actual driving is done by main.c, this is just resource |
| 31 * allocation stuff. |
| 32 * |
| 33 * This driver is modeled after the orinoco_plx driver. The main |
| 34 * difference is that the TMD chip has only IO port ranges and doesn't |
| 35 * provide access to the PCMCIA attribute space. |
| 36 * |
| 37 * Pheecom sells cards with the TMD chip as "ASIC version" |
| 38 */ |
| 39 |
| 40 #define DRIVER_NAME "orinoco_tmd" |
| 41 #define PFX DRIVER_NAME ": " |
| 42 |
| 43 #include <linux/module.h> |
| 44 #include <linux/kernel.h> |
| 45 #include <linux/init.h> |
| 46 #include <linux/delay.h> |
| 47 #include <linux/pci.h> |
| 48 #include <pcmcia/cisreg.h> |
| 49 |
| 50 #include "orinoco.h" |
| 51 #include "orinoco_pci.h" |
| 52 |
| 53 #define COR_VALUE (COR_LEVEL_REQ | COR_FUNC_ENA) /* Enable PC card with in
terrupt in level trigger */ |
| 54 #define COR_RESET (0x80) /* reset bit in the COR register */ |
| 55 #define TMD_RESET_TIME (500) /* milliseconds */ |
| 56 |
| 57 /* |
| 58 * Do a soft reset of the card using the Configuration Option Register |
| 59 */ |
| 60 static int orinoco_tmd_cor_reset(struct orinoco_private *priv) |
| 61 { |
| 62 hermes_t *hw = &priv->hw; |
| 63 struct orinoco_pci_card *card = priv->card; |
| 64 unsigned long timeout; |
| 65 u16 reg; |
| 66 |
| 67 iowrite8(COR_VALUE | COR_RESET, card->bridge_io); |
| 68 mdelay(1); |
| 69 |
| 70 iowrite8(COR_VALUE, card->bridge_io); |
| 71 mdelay(1); |
| 72 |
| 73 /* Just in case, wait more until the card is no longer busy */ |
| 74 timeout = jiffies + (TMD_RESET_TIME * HZ / 1000); |
| 75 reg = hermes_read_regn(hw, CMD); |
| 76 while (time_before(jiffies, timeout) && (reg & HERMES_CMD_BUSY)) { |
| 77 mdelay(1); |
| 78 reg = hermes_read_regn(hw, CMD); |
| 79 } |
| 80 |
| 81 /* Still busy? */ |
| 82 if (reg & HERMES_CMD_BUSY) { |
| 83 printk(KERN_ERR PFX "Busy timeout\n"); |
| 84 return -ETIMEDOUT; |
| 85 } |
| 86 |
| 87 return 0; |
| 88 } |
| 89 |
| 90 |
| 91 static int orinoco_tmd_init_one(struct pci_dev *pdev, |
| 92 const struct pci_device_id *ent) |
| 93 { |
| 94 int err; |
| 95 struct orinoco_private *priv; |
| 96 struct orinoco_pci_card *card; |
| 97 void __iomem *hermes_io, *bridge_io; |
| 98 |
| 99 err = pci_enable_device(pdev); |
| 100 if (err) { |
| 101 printk(KERN_ERR PFX "Cannot enable PCI device\n"); |
| 102 return err; |
| 103 } |
| 104 |
| 105 err = pci_request_regions(pdev, DRIVER_NAME); |
| 106 if (err) { |
| 107 printk(KERN_ERR PFX "Cannot obtain PCI resources\n"); |
| 108 goto fail_resources; |
| 109 } |
| 110 |
| 111 bridge_io = pci_iomap(pdev, 1, 0); |
| 112 if (!bridge_io) { |
| 113 printk(KERN_ERR PFX "Cannot map bridge registers\n"); |
| 114 err = -EIO; |
| 115 goto fail_map_bridge; |
| 116 } |
| 117 |
| 118 hermes_io = pci_iomap(pdev, 2, 0); |
| 119 if (!hermes_io) { |
| 120 printk(KERN_ERR PFX "Cannot map chipset registers\n"); |
| 121 err = -EIO; |
| 122 goto fail_map_hermes; |
| 123 } |
| 124 |
| 125 /* Allocate network device */ |
| 126 priv = alloc_orinocodev(sizeof(*card), &pdev->dev, |
| 127 orinoco_tmd_cor_reset, NULL); |
| 128 if (!priv) { |
| 129 printk(KERN_ERR PFX "Cannot allocate network device\n"); |
| 130 err = -ENOMEM; |
| 131 goto fail_alloc; |
| 132 } |
| 133 |
| 134 card = priv->card; |
| 135 card->bridge_io = bridge_io; |
| 136 |
| 137 hermes_struct_init(&priv->hw, hermes_io, HERMES_16BIT_REGSPACING); |
| 138 |
| 139 err = request_irq(pdev->irq, orinoco_interrupt, IRQF_SHARED, |
| 140 DRIVER_NAME, priv); |
| 141 if (err) { |
| 142 printk(KERN_ERR PFX "Cannot allocate IRQ %d\n", pdev->irq); |
| 143 err = -EBUSY; |
| 144 goto fail_irq; |
| 145 } |
| 146 |
| 147 err = orinoco_tmd_cor_reset(priv); |
| 148 if (err) { |
| 149 printk(KERN_ERR PFX "Initial reset failed\n"); |
| 150 goto fail; |
| 151 } |
| 152 |
| 153 err = orinoco_init(priv); |
| 154 if (err) { |
| 155 printk(KERN_ERR PFX "orinoco_init() failed\n"); |
| 156 goto fail; |
| 157 } |
| 158 |
| 159 err = orinoco_if_add(priv, 0, 0, NULL); |
| 160 if (err) { |
| 161 printk(KERN_ERR PFX "orinoco_if_add() failed\n"); |
| 162 goto fail; |
| 163 } |
| 164 |
| 165 pci_set_drvdata(pdev, priv); |
| 166 |
| 167 return 0; |
| 168 |
| 169 fail: |
| 170 free_irq(pdev->irq, priv); |
| 171 |
| 172 fail_irq: |
| 173 pci_set_drvdata(pdev, NULL); |
| 174 free_orinocodev(priv); |
| 175 |
| 176 fail_alloc: |
| 177 pci_iounmap(pdev, hermes_io); |
| 178 |
| 179 fail_map_hermes: |
| 180 pci_iounmap(pdev, bridge_io); |
| 181 |
| 182 fail_map_bridge: |
| 183 pci_release_regions(pdev); |
| 184 |
| 185 fail_resources: |
| 186 pci_disable_device(pdev); |
| 187 |
| 188 return err; |
| 189 } |
| 190 |
| 191 static void __devexit orinoco_tmd_remove_one(struct pci_dev *pdev) |
| 192 { |
| 193 struct orinoco_private *priv = pci_get_drvdata(pdev); |
| 194 struct orinoco_pci_card *card = priv->card; |
| 195 |
| 196 orinoco_if_del(priv); |
| 197 free_irq(pdev->irq, priv); |
| 198 pci_set_drvdata(pdev, NULL); |
| 199 free_orinocodev(priv); |
| 200 pci_iounmap(pdev, priv->hw.iobase); |
| 201 pci_iounmap(pdev, card->bridge_io); |
| 202 pci_release_regions(pdev); |
| 203 pci_disable_device(pdev); |
| 204 } |
| 205 |
| 206 static DEFINE_PCI_DEVICE_TABLE(orinoco_tmd_id_table) = { |
| 207 {0x15e8, 0x0131, PCI_ANY_ID, PCI_ANY_ID,}, /* NDC and OEMs, e.g. ph
eecom */ |
| 208 {0,}, |
| 209 }; |
| 210 |
| 211 MODULE_DEVICE_TABLE(pci, orinoco_tmd_id_table); |
| 212 |
| 213 static struct pci_driver orinoco_tmd_driver = { |
| 214 .name = DRIVER_NAME, |
| 215 .id_table = orinoco_tmd_id_table, |
| 216 .probe = orinoco_tmd_init_one, |
| 217 .remove = __devexit_p(orinoco_tmd_remove_one), |
| 218 .suspend = orinoco_pci_suspend, |
| 219 .resume = orinoco_pci_resume, |
| 220 }; |
| 221 |
| 222 static char version[] __initdata = DRIVER_NAME " " DRIVER_VERSION |
| 223 " (Joerg Dorchain <joerg@dorchain.net>)"; |
| 224 MODULE_AUTHOR("Joerg Dorchain <joerg@dorchain.net>"); |
| 225 MODULE_DESCRIPTION("Driver for wireless LAN cards using the TMD7160 PCI bridge")
; |
| 226 MODULE_LICENSE("Dual MPL/GPL"); |
| 227 |
| 228 static int __init orinoco_tmd_init(void) |
| 229 { |
| 230 printk(KERN_DEBUG "%s\n", version); |
| 231 return pci_register_driver(&orinoco_tmd_driver); |
| 232 } |
| 233 |
| 234 static void __exit orinoco_tmd_exit(void) |
| 235 { |
| 236 pci_unregister_driver(&orinoco_tmd_driver); |
| 237 } |
| 238 |
| 239 module_init(orinoco_tmd_init); |
| 240 module_exit(orinoco_tmd_exit); |
| 241 |
| 242 /* |
| 243 * Local variables: |
| 244 * c-indent-level: 8 |
| 245 * c-basic-offset: 8 |
| 246 * tab-width: 8 |
| 247 * End: |
| 248 */ |
OLD | NEW |