Update compat-wireless to 2.6.36-5-spn

chromeos/compat-wireless/drivers/net/wireless/rtl818x/rtl8187_dev.c

 /*
  * Linux device driver for RTL8187
  *
  * Copyright 2007 Michael Wu <flamingice@sourmilk.net>
  * Copyright 2007 Andrea Merello <andreamrl@tiscali.it>
  *
  * Based on the r8187 driver, which is:
  * Copyright 2005 Andrea Merello <andreamrl@tiscali.it>, et al.
  *
  * The driver was extended to the RTL8187B in 2008 by:
@@ skipping 555 matching lines @@
 
         i = 10;
         do {
                 msleep(2);
                 if (!(rtl818x_ioread8(priv, &priv->map->CMD) &
                       RTL818X_CMD_RESET))
                         break;
         } while (--i);
 
         if (!i) {
-                wiphy_err(dev->wiphy, "reset timeout!\n");
+                wiphy_err(dev->wiphy, "Reset timeout!\n");
                 return -ETIMEDOUT;
         }
 
         /* reload registers from eeprom */
         rtl818x_iowrite8(priv, &priv->map->EEPROM_CMD, RTL818X_EEPROM_CMD_LOAD);
 
         i = 10;
         do {
                 msleep(4);
                 if (!(rtl818x_ioread8(priv, &priv->map->EEPROM_CMD) &
@@ skipping 940 matching lines @@
                 dev->queues = 4;
 
         err = ieee80211_register_hw(dev);
         if (err) {
                 printk(KERN_ERR "rtl8187: Cannot register device\n");
                 goto err_free_dmabuf;
         }
         mutex_init(&priv->conf_mutex);
         skb_queue_head_init(&priv->b_tx_status.queue);
 
-        wiphy_info(dev->wiphy, "hwaddr %pm, %s v%d + %s, rfkill mask %d\n",
+        wiphy_info(dev->wiphy, "hwaddr %pM, %s V%d + %s, rfkill mask %d\n",
                    mac_addr, chip_name, priv->asic_rev, priv->rf->name,
                    priv->rfkill_mask);
 
 #ifdef CONFIG_RTL8187_LEDS
         eeprom_93cx6_read(&eeprom, 0x3F, &reg);
         reg &= 0xFF;
         rtl8187_leds_init(dev, reg);
 #endif
         rtl8187_rfkill_init(dev);
 
@@ skipping 41 matching lines @@
         return usb_register(&rtl8187_driver);
 }
 
 static void __exit rtl8187_exit(void)
 {
         usb_deregister(&rtl8187_driver);
 }
 
 module_init(rtl8187_init);
 module_exit(rtl8187_exit);